11 . Chassis intrusion connector (4-1 pin CHASSIS)

This connector is for a chassis-mounted intrusion detection sensor or switch. Connect one end of the chassis intrusion sensor or switch cable to this connector. The chassis intrusion sensor or switch sends a high-level signal to this connector when a chassis component is removed or replaced. The signal is then generated as a chassis intrusion event.

By default, the pins labeled “Chassis Signal” and “Ground” are shorted with a jumper cap. Remove the jumper caps only when you intend to use the chassis intrusion detection feature.

+5VSB MB

Chassis Signal GND

A8R32-MVP DELUXE

CHASSIS

(Default)

A8R32-MVP DELUXE Chassis intrusion connector

2 - 30

Chapter 2: Hardware information