IV. Hardware Setup

Floppy Disk Drive Cable Connections

The 1.44MB floppy disk drive requires signal and power connections. Align the red stripes of the signal and power cables so that they face each other. Carefully insert the connector while visually watching the progress so that proper alignment and insertion is made.

Setup HW .IV Cage Device 25”.5

Red stripe of signal cable

Red stripe of power cable

1.44MB Floppy Disk Drive Connections

4-4. 5.25” Device Cage

Before CD-ROM, tape, or hard disk drives can be installed or removed from the 5.25” device cage, you must remove the device cage from the chassis.

5.25” Device Cage Removal Procedure

1.Rotate the locking lever. (See 4-4. 3.25” Device Cage .)

2.Pull the device cage to the left side of the chassis.

To mount the 5.25” device cage, use the reverse procedure.

5.25” Device Bay 1

5.25” Device Bay 2

5.25” Device Bay 3

Locking Lever

5.25” Device Cage with a CD-ROM in its Topmost Bay

22

AP200 Hardware Reference Guide