Setup HW .IV
Motherboard
IV. Hardware Setup
Chassis Intrusion Photo Sensor
This motherboard has a photo sensor onboard, which detects extreme levels of light entering the chassis such as when the chassis is opened, and sends a signal to the ASMA software in such an event. To enable this function, Jumper18 must be set to Enable and an external battery must be connected to the motherboard’s external battery connector. If you want to work on the inside of the chassis when an external battery is connected, you should disable Jumper18 to save the battery power.
Chassis Intrusion | Photo Sensor Setting | |
Photo Sensor | ||
JP18 | JP18 | |
| Disable | |
EXTBATT | 1 2 3 | |
Enable | ||
|
Panel Connections
Several wires should be connected to the motherboard for the IDE/SCSI activity, power, and message indicators on the front panel. Panel connections also allow for an ATX power button, reset switch, and speaker. Connect the chassis front panel wires as illustrated:
|
| Red (+) | |
Button Cell Battery |
| H.D.D. LED | |
| White | ||
for motherboard |
| ||
BIOS and clock |
| Black (+) | |
|
| ||
|
| Speaker | |
White | Red | White | |
|
| ||
Black | Violet | Violet (+) | |
Reset SW | |||
| White | ||
| White | ||
|
| ||
White | Red | Red (+) | |
Chassis Panel | Black | Power SW | |
Connectors |
| Black | |
Green | Yellow | Yellow (+) | |
Turbo LED | |||
| White | ||
| White | ||
White |
| ||
| Green (+) | ||
|
| ||
JP18 |
| Power LED | |
|
| White | |
EXTBATT |
|
| |
IR |
|
|
20 | AP200 Hardware Reference Guide |