2.9Installing a floppy disk drive

The V-Series M2V890 Barebone system comes with one 3.25-inch drive bay for a floppy disk drive.

To install a floppy disk drive:1.Remove the front panel cover.

For instructions on how to remove the front panel cover, refer to page 2-3 of section “2.3 Removing the side cover and front panel assembly”.

2.Carefully insert the floppy disk drive into the floppy drive bay until the screw holes align with the holes on the bay.

3.Secure the floppy disk drive with two screws on both sides.

3

3

2

4.Connect the floppy disk drive signal cable to the signal connector at the back of the drive.

Power cabl e

Fl oppy ri bbon cabl e

5.Connect the other end of the signal cable to the floppy disk drive connector on the motherboard. See page 4-4 for the location of the floppy disk drive connector.

6.Connect a 4-pin power cable from the power supply unit to the power connector at the back of the floppy disk drive.

2-18

Chapter 2: Basic installation