4. BIOS SETUP
UART2 Use as [Com Port]When Ir is enabled, this field activates the onboard standard infrared feature and sets the second serial UART to support the infrared module connector on the motherboard. If your system already has a second serial port connected to the onboard COM2 connector, it will no longer work if you enable the infrared feature. If you want to support a Smart Card Reader, select the Smart Card Read mode. Configuration options: [COM Port] [Ir] [Smart Card Read]
Onboard Parallel Port [378H/IRQ7]This field sets the address of the onboard parallel port connector. If you disable this feature, Parallel Port Mode and ECP DMA Select configurations will not be available. Configuration options: [Disabled] [378H/IRQ7] [278H/IRQ5]
Parallel Port Mode [ECP+EPP]This field allows you to set the operation mode of the parallel port. [Nor- mal] allows
This field allows you to configure the parallel port DMA channel for the selected ECP mode. This selection is available only if you select [ECP] or [ECP+EPP] in Parallel Port Mode above. Configuration options: [1] [3]
Onboard MIDI IRQ [xx]This field is not available if you select [Disabled] for the Onboard MIDI I/O field. Configuration options: [3] [4] [5] [7] [9] [10] [11] [12] [14] [15]
Onboard CIR I/O [Disabled]This field sets the address of the onboard Consumer IR connector. Configuration options: [Disabled]
I/O Device Config
4. BIOS SETUP
ASUS | 65 |