Manuals / Brands / Computer Equipment / Computer Hardware / Asus / Computer Equipment / Computer Hardware

Asus CUV4X-DLS 6. SOFTWARE REFERENCE, 8)USB Header (10-1pin USBPORT), do not place jumper caps over these pins

1 100

Download 100 pages, 3.28 Mb

38

.3 H/WConnectors SETUP

3.HARDWARE SETUP

7)CPU Fan, Power Fan, and Chassis Fan Connectors (CPU_FAN, CPU_FAN2, PWR_FAN, CHA_FAN)

The four fan connectors support cooling fans of 350mA (4.2 Watts) or less. Orient the fans so that the heat sink fins allow airflow to go across the onboard heat sinks instead of the expansion slots. The fan wiring and plug may vary depending on the fan manufacturer. Connect the fan cable to the connector making sure that the black wire matches the ground pin. (NOTE: Use the “ Rotation” signal only with a specially designed fan with a rotation signal. You can monitor the Rotations Per Minute (RPM) using ASUS PC Probe (see 6. SOFTWARE REFERENCE).

WARNING! The CPU and/or motherboard will overheat if there is no airflow across the CPU and onboard heatsinks. Damage may occur to the motherboard and/or the CPU fan if these pins are incorrectly used. These are not jumpers,

do not place jumper caps over these pins.

CPU_FAN

CPU_FAN2

CHA_FAN

PWR_FAN

CUV4X-DLS

Rotation +12V GND

CUV4X-DLS 12-Volt Cooling Fans

8)USB Header (10-1 pin USBPORT)

If the USB port connectors on the back panel are inadequate, one USB header is available for two additional USB port connectors. Connect the USB header to a 2-port USB connector set and mount the bracket to an open slot in the chassis. (The USB connector set is optional and does not come with the motherboard package.)

USBPORT

USBP3+ GND

PowerUSB –USBP3

CUV4X-DLS

10 6

5 1

Power USB

–USBP2

USBP2+

GND

NC

CUV4X-DLS Front Panel USB Header

38	ASUS CUV4X-DLS User’s Manual

Contents

JumperFree™ PC133/VC133 133MHz FSB AGP Pro/4X Product Name: ASUS CUV4X-DLS Manual Revision: 1.03 E652 Release Date: January ASUSTeK COMPUTER INC. (Asia-Pacific) Marketing Technical Support ASUS COMPUTER INTERNATIONAL (America) ASUS COMPUTER GmbH (Europe) 3.7.1 Installing an Expansion Card 3.7.2 Assigning IRQs for Expansion Cards 3.7.3 Accelerated Graphics Port (AGP) Pro Slot 4.1.1 Upon First Use of the Computer System 4.3.1 Primary & Secondary Master/Slave 4.4.2 I/O Device Configuration 5.1.1 Windows 98 First Time Installation CUV4X-DLSMotherboard Support CD 7.1.2 Software Driver Support Federal Communications Commission Statement •This device may not cause harmful interference, and •Re-orientor relocate the receiving antenna •Increase the separation between the equipment and receiver •Consult the dealer or an experienced radio/TV technician for help 1.1How This Manual Is Organized 1.2 Item Checklist 2.1ASUS CUV4X-DLSMotherboard 2.1.1 Specifications LAN Support: Wake-On-Ring: SMBus: PCI Expansion Slots: Super 2.1.2Performance 2.1.3Intelligence 2.2Motherboard Components 2.2.1Component Locations 3.1Motherboard Layout 3.2Layout Contents SETUP H/W 3.3Hardware Setup Procedure 3.4Motherboard Settings Motherboard Frequency Settings (DIP Switches) 1)JumperFree™ Mode (JEN) 4.4 Advanced Menu Setting JEN 2)CPU External Frequency Selection (DIP_SW Switches 5–8) 3)CPU Core:BUS Frequency Multiple (DIP_SW Switches 1–4) Internal External CPU Bus Frequency Manual CPU Settings 4)Clear RTC RAM 5)LAN Setting Jumper (3-pinLAN_EN) 6)SCSI Setting Jumper (3-pinSCSI_EN) 7)USB Device Wake-upJumpers (3-pinUSBPWR1, USBPWR2) DISABLE NOTES: 3.5System Memory 3.5.1 General DIMM Notes 3.5.2Memory Installation 3.6Central Processing Unit (CPU) 3.6.1CPU Installation 3.7Expansion Cards 3.7.1 Installing an Expansion Card 3.7.2Assigning IRQs for Expansion Cards Standard Interrupt Assignments Interrupt Request Table for this Motherboard 3.7.3Accelerated Graphics Port (AGP) Pro Slot Page 3.8Connectors 3.8.1 External Connectors 3)Fast Ethernet LAN Port (RJ-45) 5)Parallel Port (Burgundy 25-pinPRINTER) Onboard Parallel Port 4.4.2 I/O Device Configuration) NOTE: Serial printers must be connected to the serial port 6)Serial Ports (Teal/Turquoise 9-pinCOM1 / 9-pinCOM2) 4.4.2I/O Device Configuration for the settings 7)Game/MIDI Ports (Gold 15-pinGAME_AUDIO) (optional) 8)Audio Connectors (Three 1/8” AUDIO) (optional) Line Out 3.8.2Internal Connectors 3)Primary (Blue) / Secondary IDE Connectors (40-1pin IDE1/IDE2) TIP: SCSI Connection Notes 5)Wake-On-LANConnector (3-pinWOL_CON) 4.4.3 Power Management 6)Wake-On-RingConnector (2-pinWOR) 6. SOFTWARE REFERENCE do not place jumper caps over these pins 8)USB Header (10-1pin USBPORT) 9)Standard Infrared Module Connector (5-pinIR) UART2 Use Infrared 4.4.2 I/O Device Configuration) 10)Chassis Intrusion Lead (4-1pin CHASSIS) 12)SMBus Connector (5-1pin SMB) 13)ASUS iPanel Connector (12-1pin AFPANEL) ASUS iPanel Audio Connector (12-1 pin AUDIO_PANEL) 15)Internal Audio Connectors (4-1pin CD, AUX, MODEM) (optional) 16)Internal Microphone Connector (3-pinMICIN) (optional) 17)System Power LED Lead (3-1pin PWR.LED) 18)System Warning Speaker Lead (4-pinSPEAKER) 19)System Message LED Lead (2-pinMSG.LED) 20)System Management Interrupt Lead (2-pinSMI) 21)ATX Power Switch / Soft-OffSwitch Lead (2-pinPWR.SW) 3.9Starting Up the First Time Award BIOS Beep Codes 4.1Managing and Updating Your BIOS 4.1.1 Upon First Use of the Computer System 1. Save Current BIOS to File Save Current BIOS To File A:\XXX-XX.XXX SETUP BIOS 4.1.2Updating BIOS Procedures Page 4.2BIOS Setup Program 4.2.1BIOS Menu Bar 4.2.2 Legend Bar General Help Saving Changes and Exiting the Setup Program Scroll Bar Sub-Menu 4.3Main Menu 4.3.1Primary & Secondary Master/Slave [User Type HDD] Translation Method [LBA] Cylinders Translation Method Head Sector CHS Capacity Maximum LBA Capacity Multi-SectorTransfers [Maximum] 4.3.2 Keyboard Features Language [English] This field displays the BIOS language version A Note about Passwords Forgot the Password Halt On [All Errors] 4.4Advanced Menu System/SDRAM Frequency Ratio [Auto] System/ PCI Frequency (MHz) CPU Level 1 Cache, CPU Level 2 Cache [Enabled] CPU Level 2 Cache ECC Check [Disabled] Processor Serial Number [Disabled] Notes for JumperFree Mode For processors with unlocked frequency multiplier System Hangup Cause for Hangup: Improper CPU Speed Cause for Hangup: Improper CPU: System Frequency Multiple Cause for Hangup: Improper 4.4.1Chip Configuration Read Around Write [Enabled] CPU-DRAM Back-BackTransaction [Enabled] Configuration options: [Enabled] [Disabled] Delayed Transaction [Disabled] PCI to DRAM Prefetch [Disabled] Video Memory Cache Mode [UC] Onboard PCI IDE Enable [Both] Memory Hole At 15M-16M[Disabled] 4.4.2I/O Device Configuration Onboard Peripheral Resource Control 4.4.3PCI Configuration ONB SCSI BIOS First [No] ONB Primary SCSI Term [Enabled] ONB Secondary SCSI Term [Enabled] USB Function [Enabled] Primary VGA BIOS [PCI Card] PCI IRQ Resource Exclusion PCI DMA Resource Exclusion PCI UMB Resource Exclusion 4.4.4 Shadow Configuration 4.5Power Menu Video Off Option [Suspend ->Off ] Video Off Method [DPMS OFF] HDD Power Down [Disabled] Suspend Mode [Disabled] PWR Button < 4 Secs [Soft Off] 4.5.1Power Up Control 4.5.2 Hardware Monitor 4.6Boot Menu Boot Sequence Plug & Play O/S [No] MPS 1.4 Support [Enabled] Reset Configuration Data [No] Boot Virus Detection [Enabled] Quick Power On Self Test [Enabled] 4.7Exit Menu Exit Saving Changes Exit Discarding Changes Load Setup Defaults Discard Changes Save Changes Page 5.1Operating Systems 5.1.1 Windows 98 First Time Installation 5.2 CUV4X-DLSMotherboard Support CD 5.2.1 Installation Menu 5.2.2Applications 6.1ASUS PC Probe 6.1.1 Starting ASUS PC Probe 6.1.2Using ASUS PC Probe Settings History Fan Control Information Hard Drives Memory Device Summary DMI Explorer Utility Execute Program 6.1.3ASUS PC Probe Task Bar Icon Page 7.1PCI-L101Fast Ethernet Card 7.1.1 Features 7.1.2 Software Driver Support 7.1.3 Question and Answer 7.2 Modem Riser 7.2.1 56K Software Modem 7.2.2 Primary/Seconday MR Layout of Primary 7.2.3Hardware Installation Procedure 7.2.4Software Setup in Windows 7.3 Glossary Boot Bus Master IDE Byte (Binary Term) COM Port Concurrent PCI LPT Port (Line Printer Port) MMX (Klamath) CPU as well as other OnNow PC100 ROM (Read Only Memory) SCSI (Small Computer System Interface) SDRAM (Synchronous DRAM) SPD for SDRAM module SSE (Streaming SIMD Extensions)