Installing a hard disk drive

1.Remove the two metal cover screws.

Keep the screws for later use.

1

2.Slide the metal cover toward the rear

panel. Lift the metal cover after the

2

side hooks are disengaged from the

HDD tray rail and optical drive shield.

 

Hand slot

English

3.Connect the 40-pin IDE cable to the IDE connector on the drive, then connect the 4-pin power plug to the HDD power connector.

4.Place the drive on the tray. Insert the tray metal tacks into the drive screw holes (two on the side and two on the bottom).

5.Secure the drive with two side screws.

6.Replace the metal cover by aligning its side hooks with the tray rail and optical drive shield. Slide the metal cover toward the front panel until it fits in place.

7.Secure the metal cover with the screws that you removed earlier.

3 5

4

6

7

Quick Setup Guide

7