BLITZ FORMULA
PRI_EIDE
NOTE: Orient the red markings (usually zigzag) on the IDE cable to PIN 1.
These connectors are for the Serial ATA signal cables for Serial ATA hard disk drives.
If you installed Serial ATA hard disk drives, you can create a RAID 0, RAID
1, RAID 5, RAID 10 configuration with the Intel® Matrix Storage Technology through the onboard Intel® ICH9R RAID controller.
• These connectors are set to Standard IDE mode by default. In Standard IDE mode, you can connect Serial ATA boot/data hard disk drives to these connectors. If you intend to create a Serial ATA RAID set using these connectors, set the [Configure SATA as] item in the BIOS to [RAID]. See section 4.3.6 SATA Configuration for details.
•For RAID 5, use at least three hard disk drives. For RAID 10, use at least four hard disk drives. Use two to four Serial ATA hard disk drives for each RAID 0 or RAID 1 set.
•Before creating a RAID set, refer to 5.4.3 Intel® RAID configurations or the manual bundled in the motherboard support DVD.
SATA1
SATA2
SATA5
BLITZ FORMULA
BLITZ FORMULA SATA connectorsGND 
RSATA_TXP1 
RSATA_TXN1 
GND 
RSATA_RXP1 
RSATA_RXN1 
GND
GND 
RSATA_TXP2 
RSATA_TXN2 
GND 
RSATA_RXP2 
RSATA_RXN2 
GND
GND 
RSATA_TXP5 
RSATA_TXN5 
GND 
RSATA_RXP5 
RSATA_RXN5 
GND
GND 
RSATA_TXP3 
RSATA_TXN3 
GND 
RSATA_RXP3 
RSATA_RXN3 
GND
GND 
RSATA_TXP4 
RSATA_TXN4 
GND 
RSATA_RXP4 
RSATA_RXN4 
GND
GND 
RSATA_TXP6 
RSATA_TXN6 
GND 
RSATA_RXP6 
RSATA_RXN6 
GND
SATA3
SATA4
SATA6
ROG Blitz Formula |