1 Chapter

•These connectors are set to [AHCI Mode] by default. If you intend to create a Serial ATA RAID set using these connectors, set the SATA Mode item in the BIOS to [RAID Mode]. Refer to section 3.6.3 SATA Configuration for details.

•Before creating a RAID set, refer to section 5.1 RAID configurations or the manual bundled in the motherboard support DVD.

•When using NCQ, set the SATA Mode in the BIOS to [AHCI Mode]. Refer to section

3.6.3 SATA Configuration for details.

2.USB 3.0 connector (20-1 pin USB3_12)

This connector allows you to connect a USB 3.0 module for additional USB 3.0 front or rear panel ports. With an installed USB 3.0 module, you can enjoy all the benefits of

USB 3.0 including faster data transfer speeds of up to 5Gbps, faster charging time for

USB-chargeable devices, optimized power efficiency, and backward compatibility with

USB 2.0.

USB3_12

H87-PRO

H87-PRO USB3.0 Front panel connector

• The USB 3.0 module is purchased separately.

• These connectors are based on xHCI specification. We recommend you to install the related driver to fully use the USB 3.0 ports under Windows® 7.

1-18

Chapter 1: Product introduction