2.IDE connectors (40-1 pin PRI_IDE, SEC_IDE)

The onboard IDE connectors are for Ultra DMA 133/100/66 signal cables. There are three connectors on each Ultra DMA 133/100/66 signal cable: blue, black, and gray. Connect the blue connector to the motherboard’s IDE connector, then select one of the following modes to configure your device(s).

 

 

 

Drive jumper

Mode

Cable

 

 

 

setting

of devices

connector

 

Single device

 

Cable-Select or Master

-

Black

 

Two devices

 

Cable-Select

Master

Black

 

 

 

 

 

Slave

Gray

 

 

 

 

Master

Master

Black or gray

 

 

 

Slave

Slave

 

 

 

 

 

•Pin 20 on the IDE connector is removed to match the covered hole on the

Ultra DMA cable connector. This prevents incorrect insertion when you connect the IDE cable.

•Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE devices.

If any device jumper is set as “Cable-Select,” make sure all other device jumpers have the same setting.

VM-K8V

r

K8V-VM IDE Connector

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

PRI IDE

 

 

 

IDE

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

SEC_

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

ASUS K8V-VM Motherboard

1-21