Asus LS99 manual 15

SCSISelect OptionsAvailable SettingsDefault Setting

SCSI Bus Interface Definitions

SCSI Controller ID		0-15	7
SCSI Controller Parity		Enabled	Disabled
		Disabled
SCSI Controller Termination:	Ch. A1	Enabled	Enabled
		Disabled
	Ch. B	Enabled	Enabled
		Disabled

	OR
Y Type Connection	Normal Connection
(Termination Disabled)	(Termination Enabled)
Additional Options
Boot Device Configuration
Boot SCSI Controller	AIC-7899 A at slot 00 02:0D:00 AIC-7899 A at slot 00 02:0D:00
	AIC-7899 B at slot 00 02:0D:01
Boot SCSI ID	0-15	0
Boot LUN Number2	0-7	0
SCSI Device Configuration
Sync Transfer Rate (MBytes/sec)	160, 80.0, 53.4, 40.0,	160
	32.0, 26.8, 20.0,
	16.0, 13.4, 10.0,
	ASYN
Initiate Wide Negotiation	Yes, No	Yes (Enabled)
Enable Disconnection	Yes, No	Yes (Enabled)
Send Start Unit Command	Yes, No	Yes (Enabled)
BIOS Multiple LUN Support3	Yes, No	No (Disabled)
Include in BIOS Scan3	Yes, No	Yes ( Enabled)
Advance Configuration
Reset SCSI Bus at IC Initialization	Enabled, Disabled	Enabled
Display <Ctrl> <A> Messages During	Enabled, Disabled	Enabled
BIOS Initialization [Auto-sync]
Extended Int 13 Translation for	Enabled, Disabled	Enabled
DOS Drives > 1 GByte
POST Display Mode [Auto-sync]	Verbose, Silent, Diagnostic	Verbose
SCSI Controller Int 13 Support	Enabled, Disabled:NOT scan,	Enabled
	Disabled:scan bus
Domain Validation3 [Auto-sync]	Enabled, Disabled	Enabled
Support Removable Disks Under Int 13	Disabled,	Disabled
as Fixed Disks3	Boot Only,
	All Disks
BIOS Support for Bootable CD-ROM3	Enabled, Disabled	Enabled
Boot Channel [Auto-sync]	A First, B First	A First
Boot SCSI ID [Auto-sync]	0-15	0
Boot LUN Number2 [Auto-sync]	0-7	0

1Leave this on its default setting.

2Setting is valid only if Multiple LUN Support is enabled.

3Settings are valid only if host adapter BIOS is enabled.

3. Configuration

Chapter 3 Configuring the ASUS LS99 15