3.Plug additional internal Ultra160 and Ultra2 SCSI devices to the other cable connectors, starting with the connector at the terminated end of the cable. Make sure to match pin-1 on all connections.

NOTE: Internal Ultra160 and Ultra2 SCSI devices come from the factory with termination disabled and cannot be changed. Proper termination is provided by the terminator at the end of the LVD SCSI cable.

4.Connect a power cable from your computer’s internal power supply to each internal SCSI device.

5.Most PC cabinets are designed with a front panel LED, which may already be connected to an existing IDE controller. You may connect this LED cable to your SCSI host adapter. This connection causes the front panel LED to indicate activity on the SCSI bus.

2.6.2 Connecting Internal Wide SCSI Devices

You can connect Wide SCSI devices to the internal LVD/SE connectors. If you do this, we recommend that you connect them to the SCSI channel A LVD/SE connector and that you connect all Ultra160 and Ultra2 devices to the SCSI Channel B connector. Follow these steps to connect Wide SCSI devices:

1.Connect one end of a 68-pin internal Wide SCSI cable to the Channel A internal 68-pin connector on the ASUS LS99 LAN/SCSI card.

2.Connect the other end of the cable to a terminated Ultra/Fast Wide SCSI device. Pin-1 must match on all connections.

3.If you have other Ultra/Fast Wide SCSI devices, attach them to the connectors between the two ends of the cable. Be sure these other devices are unterminated.

4.Connect a power cable from your computer’s internal power supply to each internal SCSI device.

2. HW Installation

Chapter 2 Hardware Installation

9