3.Serial ATA connectors
These connectors are for the Serial ATA signal cables for Serial ATA 3.0 Gb/s hard disk and optical disk drives. The Serial ATA 3.0 Gb/s is backward compatible with Serial ATA 1.5 Gb/s specification.
If you installed Serial ATA hard disk drives, you can create a RAID 0, RAID 1,
RAID 0+1, RAID 5, or JBOD configuration through the onboard NVIDIA®
MediaShield™ controller.
SATA2 SATA1 SATA4 SATA3
GND 
RSATA_TXP2 
RSATA_TXN2 
GND 
RSATA_RXP2 
RSATA_RXN2 
GND 
GND 
RSATA_TXP1 
RSATA_TXN1 
GND 
RSATA_RXP1 
RSATA_RXN1 
GND 
GND 
RSATA_TXP4 
RSATA_TXN4 
GND 
RSATA_RXP4 
RSATA_RXN4 
GND 
GND 
RSATA_TXP3 
RSATA_TXN3 
GND 
RSATA_RXP3 
RSATA_RXN3 
GND 
M2N/M2N DH SATA Connectors
The RAID function of these connectors is set to [Disabled] by default. If you intend to create a Serial ATA RAID set using these connectors, enable the nVidia RAID Function item in the BIOS. See section “4.3.4 IDE Configuration” for details.
4.Serial port connector
This connector is for a serial (COM) port. Connect the serial port module cable to this connector, then install the module to a slot opening at the back of the system chassis.
COM1
PIN1
M2N/M2N DH COM Port Connector
The COM module is purchased separately.
ASUS M2N / M2N DH |