3.HARDWARE SETUP

5)Primary / Secondary IDE Connectors (Two 40-1pin IDE)

These connectors support the provided IDE hard disk ribbon cable. After connecting the single end to the board, connect the two plugs at the other end to your hard disk(s). If you install two hard disks, you must configure the second drive to Slave mode by setting its jumper accordingly. Please refer to the documentation of your hard disk for the jumper settings. BIOS now supports SCSI device or IDE CD-ROM bootup (see Boot Sequence in 4.6 Boot Menu).

(Pin 20 is removed to prevent inserting in the wrong orientation when using ribbon cables with pin 20 plugged).

TIP: You may configure two hard disks to be both Masters with two ribbon cables – one for the primary IDE connector and another for the secondary IDE connector. You may install one operating system on an IDE drive and another on a SCSI drive and select the boot disk through Boot Sequence in 4.6 Boot Menu.

ME-99B

®

Secondary IDE Connector

 

 

 

 

Pin 1

 

 

 

 

Primary IDE Connector

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

NOTE: Orient the red markings (usually zigzag) on the IDE ribbon cable to pin 1

H/W SETUP

Connectors

3.

 

 

 

ME-99B IDE Connectors

IMPORTANT: UltraDMA/66 IDE devices must use an 80-conductor IDE cable.6)IDE activity LED (2-pin IDELED)

This connector supplies power to the cabinet’s IDE activity LED. Read and write activity by devices connected to the Primary or Secondary IDE connectors will cause the LED to light up.

TIP: If the case-mounted LED does not light, try reversing the 2-pin plug.

ME-99B

IDELED

®

ME-99B IDE Activity LED

ASUS ME-99B User’s Manual

29