This connector supplies power to the hard disk activity LED. The read or write activities of any device connected to the primary/secondary IDE connectors or the SATA connectors cause this LED to light up.
HDLED1
1
SCSI_ACTLED+
SCSI_ACTLED-
SCSI_ACTLED-
SCSI_ACTLED+
NCLV(Series)
SCSI/SATA card activity LED connector
6 . CPU and system fan connectors
The fan connectors support cooling fans of 350 mA ~ 740 mA (8.88 W max.) or a total of 2.1 A ~ 4.44 A (53.28 W max.) at +12V. Connect the fan cables to the fan connectors on the motherboard, making sure that the black wire of each cable matches the ground pin of the connector.
Do not forget to connect the fan cables to the fan connectors. Insufficient air flow inside the system may damage the motherboard components. These are not jumpers! Do not place jumper caps on the fan connectors!
REAR_FAN1
REAR_FAN2
CPU_FAN1
CPU_FAN2
FRNT_FAN1
FRNT_FAN2
NCLV(Series) Fan connectors
REAR_FAN1 | REAR_FAN2 | ||||||||||
|
|
|
|
|
|
| GND +12V Rotation | ||||
|
|
|
|
|
| ||||||
| Rotation +12V GND | ||||||||||
|
|
|
|
| |||||||
|
|
|
|
| |||||||
CPU_FAN1 | CPU_FAN2 | ||||||||||
GND FANPWR2 FANOUT4 | GND FANPWR2 FANOUT4 | ||||||||||
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
| ||
FRNT_FAN1 | FRNT_FAN2 | ||||||||||
|
|
|
|
| |||||||
|
|
|
|
|
| ||||||
| Rotation +12V GND |
| Rotation +12V GND | ||||||||
2 - 34 | Chapter 2: Hardware information |