Asus P/I-AP55TV Chipset Features Setup, ASUS P/I-AP55TVUser’s Manual, 15.Power Input Connector (12-pinblock), 14.IrDA-CompliantInfrared Module Connector (IR)

III.INSTALLATION

14.IrDA-Compliant Infrared Module Connector (IR)

This connector supports the optional wireless transmitting and receiving infra- red module. This module mounts to a small opening on system cases that sup- port this feature. You must also configure the setting through "UART2 Use Infrared" in Chipset Features Setup to select whether UART2 is directed for use with COM2 or IrDA. Use the five pins as shown on the Back View and connect a ribbon cable from the module to the motherboard according to the pin definitions.

Front View Back View

+5V

NC

IRRX

GND

IRTX

IRTX +5V

GND NC

IRRX

Infrared Module Connector

15.Power Input Connector (12-pin block)

This connector connects to a standard 5 Volt power supply. To connect the leads from the power supply, ensure first that the power supply is not plugged. Most power supplies provide two plugs (P8 and P9), each containing six wires, two of which are black. Orient the connectors so that the black wires are located in the middle.

		PG		ORG
	+5V		P8	RED
		+12V		YLW
-12V				BLU
				BLK
		GND		BLK
				BLK
				BLK
				WHT
	-5V		P9	RED
				RED
		+5V		RED
AT Power Connector			Power Plugs from
on Motherboard			Power Supply

Using a slight angle, align the plastic guide pins on the lead to their receptacles on the connector. Once aligned, press the lead onto the connector until the lead locks into place.

INSTALLATION	(Connectors)
III.

ASUS P/I-AP55TV User’s Manual 23