III.INSTALLATION
5.External Connectors
WARNING: Some pins are used for connectors or power sources. These are clearly separated from jumpers in "Map of the Motherboard" on page 4. Placing jumper caps over these will cause damage to your motherboard.
IMPORTANT: Ribbon cables should always be connected with the red stripe on the Pin 1 side of the connector. The four corners of the connectors are labeled on the motherboard. Pin 1 is the side closest to the power connector on hard drives and floppy drives. IDE ribbon cable must be less than 18in. (46cm), with the second drive connector no more than 6in. (15cm) from the first con- nector.
1.PS/2 Keyboard Connector
This connection is for a standard keyboard using an PS/2 plug (mini DIN).
This connector will not allow standard AT size (large DIN) keyboard plugs. You may use a DIN to mini DIN adapter on standard AT keyboards.
PS/2 Keyboard Connector
2.PS/2 Mouse Connector
The system will direct IRQ12 to the PS/2 mouse if one is detected. If not detected, expansion cards can use IRQ12. See PS/2 Mouse Control in BIOS FEATURES SETUP.
PS/2 Mouse Connector
3.Parallel Printer Connector (25 female)
You can enable the parallel port and choose the IRQ through BIOS Setup on page 37 "Onboard Parallel Port."
Parallel Printer Connector
4.Serial port COM1 and COM2 Connectors (Two
The two serial ports can be used for pointing devices or other serial devices. See page 36 for BIOS configuration of "Onboard Serial Port"
COM 1 | COM 2 |
INSTALLATION | (Connectors) |
III. |
|
|
|
ASUS | 19 |