III.INSTALLATION
6.Primary / Secondary IDE connectors (Two
This connector supports the provided IDE hard disk ribbon cable. After con- necting the single end to the board, connect the two plugs at the other end to your hard disk(s). If you install two hard disks, you must configure the second drive to Slave mode by setting its jumpers accordingly. Please refer to the documentation of your hard disk for the jumper settings. You may also config- ure two hard disks to be both Masters using one ribbon cable on the primary IDE connector and another ribbon cable on the secondary IDE connector. Pin 20 is removed to prevent inserting in the wrong orientation when using ribbon cables with pin 20 plugged).
Pin 1 | Secondary IDE Connector | ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Primary IDE Connector
7.Floppy Drive Connector
This connector supports the provided floppy drive ribbon cable. After con- necting the single end to the board, connect the two plugs on the other end to the floppy drives. (Pin 5 is removed to prevent inserting in the wrong ori- entation when using ribbon cables with pin 5 plugged).
Floppy Drive Connector
Pin 1 
INSTALLATION | (Connectors) |
III. |
|
|
|
ASUS | 21 |