INSTALLATION .III

Connectors

III.INSTALLATION

11.IrDA-Compliant infrared module connector (5-pin IR)

This connector supports the optional wireless transmitting and receiving infrared module. This module mounts to a small opening on system cases that support this feature. You must also configure the setting through “UART2 Use Infrared” in Chipset Features Setup to select whether UART2 is directed for use with COM2 or IrDA. Use the five pins as shown on the Back View and connect a ribbon cable from the module to the motherboard according to the pin definitions.

Front View

Back View

+5V

(NC)

IRRX

GND

IRTX

IRTX+5V

GND(NC)

IRRX

P2B-VM Infrared Module Connector

12.Wake-On-LAN Connector (3-pin WOL_CON)

These connector connects to LAN cards with a Wake On LAN output, such as the ASUS PCI-L101. The connector powers up the system when a wakeup packet or signal is received through the LAN card.

IMPORTANT: This feature requires that the WAKE On LAN Power Up Con- trol is set to Enabled (see “Power Management Setup” under BIOS SOFT- WARE section) and that your system has an ATX power supply with at least 720mA +5V standby power.

+5 Volt Standby

Ground

PME

IMPORTANT: Requires an ATX power supply with at least 720mA +5Volt standby power

P2B-VM Wake-On-LAN Connector

30

ASUS P2B-VM User’s Manual