III.INSTALLATION

17.Message LED Lead (2-pin MLED)

This indicates whether a message has been received from a fax/modem. The LED will remain lit when there is no signal and blink when data are being transfer or messages are waiting in the inbox. This function requires ACPI OS support.

18.Keyboard Lock Switch Lead (2-pin KEYLOCK)

This 2-pin connector connects to the case-mounted key switch to allow key- board locking.

19.System Management Interrupt Lead (2-pin SMI)

This allows the user to manually place the system into a suspend mode or “Green” mode where system activity will be instantly decreased to save electricity and expand the life of certain components when the system is not in use. This 2-pin connector (see the figure below) connects to the case-mounted suspend switch. If you do not have a switch for the connector, you may use the “Turbo Switch” since it does not have a function. SMI is activated when it detects a short to open moment and therefore leaving it shorted will not cause any problems. May require one or two pushes depending on the position of the switch. Wake-up can be controlled by settings in the BIOS but the keyboard will always allow wake- up (the SMI lead cannot wake-up the system). If you want to use this connector, “Suspend Switch” in the Power Management Setup of the BIOS SOFTWARE section should be on the default setting of Enable.

20.Speaker Connector (4-pin SPEAKER)This 4-pin connector connects to the case-mounted speaker.21.ATX Power Switch/Soft Power Switch (2-pin PWR)

The system power is controlled by a momentary switch connected to this lead. Pushing the button once will switch the system between ON and SLEEP. Push- ing the switch while in the ON mode for more than 4 seconds will turn the system off. The system power LED shows the status of the system’s power.

22.IDE Activity LED (2-pin IDELED)

This 2-pin connector supplies power to the cabinet’s IDE activity LED. Read and write activity by devices connected to the Primary or Secondary IDE con- nectors will cause the LED to light up.

23.System Power LED (3-1 pin PLED)

This 3-1 pin connector connects the system power LED, which lights when the system is powered on and blinks when it is in sleep mode.

24.Reset Switch Lead (2-pin RESET)

This 2-pin connector connects to the case-mounted reset switch for rebooting your computer without having to turn off your power switch This is a preferred method of rebooting to prolong the life of the system’s power supply.

Keyboard Lock

SMI Lead

Message LED

Speaker Connector

+

+5V GND GND SPKR

+

+

ATX Power Switch

Reset Switch

IDELED

Power LED

P2B-VM System Panel Connectors

INSTALLATION

Connectors

III.

 

 

 

ASUS P2B-VM User’s Manual

33