INSTALLATION .III

Connectors

III.INSTALLATION

9.Primary / Secondary IDE Connectors (Two 40-1pin IDE)

These connectors support the provided IDE hard disk ribbon cable. After connecting the single end to the board, connect the two plugs at the other end to your hard disk(s). If you install two hard disks, you must configure the second drive to Slave mode by setting its jumper accordingly. Refer to the documentation of your hard disk for the jumper settings. (Pin 20 is removed to prevent inserting in the wrong orientation when using ribbon cables with pin 20 plugged).

NOTE: Orient the red stripe to Pin 1

Pin 1

Secondary IDE Connector

Primary IDE Connector

IDE Connectors

10.IDE activity LED (2-pin IDELED)

This connector supplies power to the cabinet’s IDE activity LED. Read-and-write activity by devices connected to the IDE connectors will cause the LED to light up.

IDELED

(IDE Signal) + (+5V)

IDE Activity LED

11.Wake on LAN Connector (3-pin WOL_CON)

This connector coonects to LAN cards with a Wake On LAN output. When the system is in soft-off mode, LAN activity will power on the system.

+5-Volt Standby

PME

Ground

IMPORTANT: Requires an ATX power supply with at least 720mA +5-volt standby power

Wake on LAN Connector

26

ASUS P2L97A User’s Manual