3.HARDWARE SETUP

8.IDE Device Activity LED (2-pin IDELED)

This connector supplies power to the cabinet’s IDE device activity LED. Read and write activity by devices connected to the Primary or Secondary IDE con- nectors will cause the LED to light up.

TIP: If the case-mounted LED does not light, try reversing the 2-pin plug.

IDELED

P3V133

P3V133 IDE Activity LED

9.Wake-On-Ring Connector (2-pin WOR)

This connector connects to internal modem cards with a Wake-On-Ring output. The connector powers up the system when a ringup packet or signal is received through the internal modem card. NOTE: For external modems, Wake-On-Ring is detected through the COM port.

IMPORTANT: This feature requires that the PWR UP On Modem Act Power Up Control is set to Enabled (see Power Management Setup under BIOS SETUP).

 

WOR

 

Ground PIXRI#

P3V133

Pin1 Pin2

P3V133 Wake-On-Ring Connector

.3 SETUPH/W

Connectors

ASUS P3V133 User’s Manual

35