3.HARDWARE SETUP

11.Wake-On-LAN Connector (3-pin WOL_CON)

The WOL_CON connector powers up the system when a wake-up packet or signal is received from the network through an optional PCI-L101 LAN card.

IMPORTANT: This feature requires that the Wake-On-LANPower Up Control is set to Enabled (see Power Management Setup under BIOS SETUP) and that your system has an ATX power supply with at least 720mA +5V standby power.

 

WOL_CON

 

 

Ground

P3V133

VoltStandby

Connection)

 

+5

(No

P3V133 Wake on LAN Connector

12.IrDA-Compliant Infrared Module Connector (5-pin IR)

This connector supports the optional wireless transmitting and receiving infrared module. This module mounts to a small opening on system cases that support this feature. You must also configure the setting through “UART2 Use Infrared” in Chipset Features Setup to select whether UART2 is directed for use with COM2 or IrDA. Use the five pins as shown on the Back View and connect a ribbon cable from the module to the motherboard according to the pin definitions.

 

Front View

Back View

 

 

+5V IRRX IRTX

 

 

 

(NC) GND

 

 

 

 

IRTX

+5V

 

 

GND

FIRRX

 

 

IRRX

 

P3V133

For the infrared feature to be available,

 

you must connect the optional Infrared

 

(IrDA) module to the motherboard.

P3V133 Infrared Module Connector

.3 SETUPH/W

Connectors

ASUS P3V133 User’s Manual

37