.3

H/WCPU SETUP

3.HARDWARE SETUP

3.6.4Installing the Processor

NOTE: The following steps assume that you have already attached the heatsink and installed the URM into your motherboard.

1. Make sure that the processor substrate key is aligned with the Slot 1 connector key.

Connector Key

Substrate Key

2.Push down firmly but gently the SECC2/SECC/SEPP into the URM until it snaps into place.

NOTE: The processor edge fingers must be kept parallel to the connector or else misalignment will occur.

SECC for Pentium II only: Secure the SECC in place by pushing the two SECC locks outward so that the locks show through the retention mechanism’s lock holes.

SECC2/SEPP: When engaged, the T-bars lock into the slots at the two ends of the SECC2/SEPP heatsink.

SECC

SECC2/SEPP

Lock hole

 

 

 

Lock hole

CPU fan

 

 

CPU fan cable to

 

cable to fan

fan connector

 

connector

3. If your URM is of type A, make sure the locks are in the locked position as shown.

Locked Position (push upward)

26

ASUS P3V4X User’s Manual