Asus P3V4X NOTE:, ASUS P3V4X User’s Manual, 15.ATX Power Supply Connector (20-pinATXPWR), 16.Chassis Intrusion Alarm Lead (optional) (4-1pin CHASSIS)

3.HARDWARE SETUP

15.ATX Power Supply Connector (20-pin ATXPWR)

This connector connects to an ATX power supply. The plug from the power supply will only insert in one orientation because of the different hole sizes. Find the proper orientation and push down firmly but gently making sure that the pins are aligned.

	+3.3	Volts	+3.3 Volts
	-12.0 Volts		+3.3 Volts
	Ground		Ground
	Power Supply On		+5.0 Volts
P3V4X	Ground		Ground
	Ground		+5.0 Volts
	Ground		Ground
	-5.0 Volts		Power Goo
	+5.0 Volts		+5V Standb
	+5.0 Volts		+12.0 Volts

P3V4X ATX Power Connector

IMPORTANT: Make sure that your ATX power supply can supply at least 10mA on the 5-volt standby lead (5VSB). You may experience difficulty in powering on your system if your power supply cannot support the load. For Wake-On- LAN support, your ATX power supply must supply at least 720mA +5VSB.

16.Chassis Intrusion Alarm Lead (optional) (4-1 pin CHASSIS)

This requires an external detection mechanism such as a chassis intrusion moni- tor/sensor or microswitch. The sensor is triggered when a high level signal is sent to the Chassis Signal lead, which occurs when a panel switch or light detec- tor is triggered. This function requires the optional CIDB chassis sensor module to be installed.

NOTE: When the chassis is opened, connect/short the Chassis Signal pin to the +5VSB pin. When the chassis is closed, connect/short the Chassis Signal pin to the Ground pin.

	+5VSB	Signal	GND
P3V4X		Chassis

CHASSIS

P3V4X Chassis Intrusion Alarm Lead

.3 SETUPH/W

Connectors

ASUS P3V4X User’s Manual 39