10.Bass/Center setting (3-pin BCS1, BCS2) (on audio models only)

These jumpers allow you to select the speaker output for a 6-channel audio system. Switch the jumpers from the CENTER/BASS (pins 2-3) position to BASS/CENTER (pins 1-2) position to re-route signals on the internal leads of the Mic port.

Use the audio driver included in the support CD to install the multi- channel audio feature. See section “5.3 Software information.”

P4B533-V

BCS1

BCS2

1

2

2

3

 

 

 

 

 

(BASS/CENTER) (CENTER/BASS)

P4B533-V Bass Center Setting

(Default)

 

11.Line out selector (2-pin FP_LO_SWL1, FP_LO_SWR1) (on audio models only)

By default, these jumpers are shorted (jumper caps on) to route the signal from the audio controller to the rear panel Line Out jack to make it available for audio out devices such as speakers or a headphone.

If you connect the Intel Front Panel audio cable to the FP_AUDIO1 connector (see page 2-32 for the location), remove the caps from these jumpers to allow automatic switching of audio signal between the rear panel Line Out jack and the audio cable.

P4B533-V

BLOL

FLOL

BLOR

FLOR

FP_LO_SWR1 FP_LO_SWL1

P4B533-V Internal Line Out Connectors

2-22

Chapter 2: Hardware information

Page 48
Image 48
Asus P4B533-V manual Bass/Center setting 3-pin BCS1, BCS2 on audio models only