6. Bass Center Setting (2x3 pin BCS1, BCS2)

Use these jumpers in conjunction with the 6 channel Audio Driver and to adjust output for 4 or 6 speaker audio. No audio standard exists for the three pick-up surfaces on male audio jacks; therfore, it may be necessary to switch jumpers from the default position Center/Bass to Bass/Center in order to reroute signals among the internal leads of the Line-In,Line-Out, Mic female sockets. Make sure a test is made using the Audio Driver software setup available on the Support CD.

BCS1

BCS2

 

1

2

2

3

P4T533-C

(BASS/CENTER)

(CENTER/BASS)

 

 

 

(Default)

P4T533-C Bass Center Setting

7. Keyboard Wake Up (3 pin KBPWR)

This jumper disables or enables the keyboard power up function. The default is set to [1-2], +5V, which disables keyboard power up. Select +5VSB to enable keyboard power up (by pressing <Spacebar>) . This feature requires an ATX power supply that can supply at least 300mA on the +5VSB lead. The default is set to Enable. (The computer will not power ON if you set this to Enable but do not have the correct ATX power supply. NOTE: This jumper must be set in conjunction with the BIOS setting: in 4.5.1 Power Up Control: Wake On PS2 Keyboard.

KBPWR

1

2

2

3

 

 

 

 

 

+5V +5VSB (Default)

P4T533-C

P4T533-C Keyboard Power Setting

26

Chapter 2: Hardware information