The following item appears only when you installed an Intel® Pentium® 4 or later CPU that supports the Enhanced Intel SpeedStep® Technology (EIST).

Intel(R) SpeedStep Technology [Automatic]

Allows you to use the Enhanced Intel® SpeedStep® Technology. When set to [Enabled], you can adjust the system power settings in the operating system to use the EIST feature. Set this item to [Disabled] if you do not want to use the EIST. Configuration options: [Automatic] [Disabled]

Intel(R) C-STATE Technology [Enabled]

Allows you to enable or disable the C-STATE technology. Configuration options: [Enabled] [Disabled]

2.4.4Chipset

The Chipset menu allows you to change the advanced chipset settings. Select an item then press <Enter> to display the sub-menu.

Chipset Settings

WARNING: Setting wrong values in below sections may cause the system to malfunction.

NorthBridge Configuration

NorthBridge Configuration

North Bridge chipset Configuration

Memory Remap Feature

[Disabled]

Configure DRAM Timing by SPD

[Enabled]

Initiate Graphic Adapter

[PEG/PCI]

Initiate Graphic Mode Select

[Enabled, 8MB]

DVMT Mode Select

[Fixed Mode]

DVMT/FIXED Memory

[128MB]

PEG Port Configuration

 

PEG Force x1

[Disabled]

Memory Remapping Feature [Disabled]

Allows you to enable or disable the remapping of the overlapped PCI memory above the total physical memory. Enable this option only when you install 64-bit operating system.

Configuration options: [Disabled] [Enabled]

2-22

Chapter 2: BIOS setup