Asus P5GL-MX Internal connectors, PS/2 keyboard port purple. This port is for a PS/2 keyboard

7 . USB 2.0 ports 3 and 4. These two 4-pin Universal Serial Bus (USB) ports are available for connecting USB 2.0 devices.

8 . USB 2.0 ports 1 and 2. These two 4-pin Universal Serial Bus (USB) ports are available for connecting USB 2.0 devices.

9 . VGA port. This 15-pin port connects to a VGA monitor.

10 . Serial connector. This 9-pin COM1 port is for serial devices.

1 1 . PS/2 keyboard port (purple). This port is for a PS/2 keyboard.

1.10.2 Internal connectors

1 . Primary IDE connector (40-1 pin PRI_IDE)

This connector is for an Ultra DMA 100/66 signal cable. The Ultra DMA 100/66 signal cable has three connectors: a blue connector for the primary IDE connector on the motherboard, a black connector for an Ultra DMA 100/66 IDE slave device (optical drive/hard disk drive), and a gray connector for an Ultra DMA 100/66 IDE master device (hard disk drive). If you install two hard disk drives, you must configure the second drive as a slave device by setting its jumper accordingly. Refer to the hard disk documentation for the jumper settings.

¥ Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA cable connector. This prevents incorrect insertion when you connect the IDE cable.

¥Use the 80-conductor IDE cable for Ultra DMA 100/66 IDE devices.

P5GL-MX

PRI_IDE1

NOTE: Orient the red markings (usually zigzag) on the IDE ribbon cable to PIN 1.

P5GL-MX IDE connector PIN 1

ASUS P5GL-MX 1 - 27