For WiFi-AP Edition Only:

Refer to the WiFi-AP Solo user guide for detail configuration and settings.

10.Wireless LAN port. This port is on the onboard wireless LAN module that allows you to set up a wireless network and exchange information with other wireless devices without tagling cables and wires. Connect the moveable omni-directional antenna to this port.

11.Wireless LAN Activity LED. The wireless module comes with an activity LED.

12.Microphone port (pink). This port connects a microphone.

13.Side Speaker Out port (gray). This port connects the side speakers in an

8-channel audio configuration.

Refer to the audio configuration table below for the function of the audio ports in 2, 4, 6, or 8-channel configuration.

Audio 2, 4, 6, or 8-channel configuration

Port

Headset

4-channel

6-channel

8-channel

 

2-channel

 

 

 

Light Blue

Line In

Line In

Line In

Line In

Lime

Line Out

Front Speaker Out

Front Speaker Out

Front Speaker Out

Pink

Mic In

Mic In

Mic In

Mic In

Orange

–

–

Center/Subwoofer

Center/Subwoofer

Black

–

Rear Speaker Out

Rear Speaker Out

Rear Speaker Out

Gray

–

–

–

Side Speaker Out

14.USB 2.0 ports 1 and 2. These 4-pin Universal Serial Bus (USB) ports are available for connecting USB 2.0 devices.

15.External SATA port 1/2. These port connect to an external a Serial ATA hard disk drive. To configure a RAID0, RAID1, or JBOD set, connect external

Serial ATA hard disk drives to the External SATA port 1 and 2.

The external SATA port supports external Serial ATA 3.0 Gb/s devices. Longer cables support higher power requirements to deliver signal up to two meters away, and enables improved hot- swap function.

2-24

Chapter 2: Hardware information