Asus P5LD2-VM DH 1.10.2 Internal connectors, Cable Select Mode, Jumper Select Mode, P5LD2-VMDH Floppy disk drive connector, 2 . Primary IDE connector (40-1pin PRI_IDE)

1.10.2 Internal connectors

1 . Floppy disk drive connector (34-1 pin FLOPPY)

This connector is for the provided floppy disk drive (FDD) signal cable. Insert one end of the cable to this connector, then connect the other end to the signal connector at the back of the floppy disk drive.

Pin 5 on the connector is removed to prevent incorrect cable connection when using an FDD cable with a covered Pin 5.

P5LD2-VM DH

FLOPPY

NOTE: Orient the red markings on the floppy ribbon cable to PIN 1.

PIN 1

P5LD2-VM DH Floppy disk drive connector2 . Primary IDE connector (40-1 pin PRI_IDE)

These connectors are for Ultra DMA 133/100/66 signal cables. There are three interfaces on each Ultra DMA 133/100/66 signal cable: blue, black, and gray. Connect the blue interface into the motherboard’s IDE connector, then select one of the following modes to configure your hard disk drive(s).

Cable Select Mode - use this mode to select the operating mode by					e
	cable connectors.
	No. of drives	Drive type	Drive jumper	Cable connector
	1	With OS		black
	2	With OS	Cable select	black
		Without OS		gray
Jumper Select Mode - use this mode to select the operating mode by
	hard disk drive jumper.
	No, of drives	Drive type	Drive jumper	Cable connector
	1	With OS	Master
	2	With OS	Master	black or gray
		Without OS	Slave

1 - 26 Chapter 1: Product introduction