12 . Front panel audio connector (10-1 pin AAFP)

This connector is for a chassis-mounted front panel audio I/O module that supports either HD Audio or legacy AC’97 audio standard.

 

 

 

 

AAFP

 

DH

 

Azalia

 

Legacy ACí97

-VM

compliant definition

compliant definition

P5LD2

GND

PRESENCE#

SENSE1 RETUR

SENSE2 RETUR

AGND +5VA BLINE OUT R

BLINE OUT L

 

PORT1 L

PORT1 R

PORT2 R SENSE SEND

PORT2 L

MIC2 MICPWR Line out R

NC Line out L

P5LD2-VM DH Analog front panel connector

 

 

 

It is recommended that you connect a high-definition front panel audio module to this connector to avail of the motherboard’s high-definition audio capability.

13 . Chassis intrusion connector (4-1 pin CHASSIS)

This connector is for a chassis-mounted intrusion detection sensor or switch. Connect one end of the chassis intrusion sensor or switch cable to this connector. The chassis intrusion sensor or switch sends a high-level signal to this connector when a chassis component is removed or replaced. The signal is then generated as a chassis intrusion event.

By default, the pins labeled “Chassis Signal” and “Ground” are shorted with a jumper cap. Remove the jumper caps only when you intend to use the chassis intrusion detection feature.

P5LD2-VM DH

CHASSIS

GND (Default)

Chassis Signal

+5VSB_MB

P5LD2-VM DH Chassis intrusion connector

1 - 34

Chapter 1: Product introduction