Asus P5LD2 16 . ATX power connectors, (24-pinEATXPWR, 8-pinEATX12V, 4-pinEZ_PLUG)

16 . ATX power connectors(24-pin EATXPWR, 8-pin EATX12V, 4-pin EZ_PLUG)

These connectors are for ATX power supply plugs. The power supply plugs are designed to fit these connectors in only one orientation. Find the proper orientation and push down firmly until the connectors completely fit.

	DC	DC	DC	DC			EATXPWR
	+12V	+12V	+12V	+12V
EATX12V						+3	Volts	Ground
DELUXE						+12	Volts	+5 Volts
						+12	Volts	+5 Volts
P5LD2
					+5V Standby			+5 Volts
	GND	GND	GND	GND		Power OK		-5 Volts
						Ground		Ground
						+5	Volts	Ground
			+5V			Ground		Ground
EZ_PLUG			EZ_DET			+5 Volts		PSON#
			GND
						Ground		Ground
			+12V
						+3	Volts	-12 Volts
P5LD2 DELUXE ATX power connectors
						+3	Volts	+3 Volts

¥You may use a 4-pin ATX12V power plug for this connector.

¥Make sure to remove the cap on the connector before connecting an 8-pin EPS +12V power plug.

¥Use only either a 4-pin ATX12V or an 8-pin EPS +12V power plug. Connecting other power plug types may serious damage to the system.

EATX12V

Remove the cap before using an

8-pin power plug

Connec t a 4 - pi n power plu g here

Important notes on motherboard power requirements

¥When installing two VGA cards using a 20-pin ATX PSU with +12V capability, we recommend that you connect the EZ Plug for sufficient power. Refer to the PSU documentation for dual VGA power requirements.

¥For a fully configured system, we recommend that you use a power supply unit (PSU) that complies with ATX 12 V Specification 2.0 (or later version) and provides a minimum power of 350 W.

¥Do not forget to connect the 8-pin/4-pin ATX12 V power plug; otherwise, the system will not boot up.

¥Use of a PSU with a higher power output is recommended when configuring a system with more power consuming devices. The system may become unstable or may not boot up if the power is inadequate.

ASUS P5LD2 Deluxe 2 - 33