1.7.3Installing a DIMM
Unplug the power supply before adding or removing DIMMs or other system components. Failure to do so can cause severe damage to both the motherboard and the components.
To install a DIMM:
1. Press the retaining clips outward to unlock a DDR2 DIMM socket.
2. Align a DIMM on the socket such that the notch on the DIMM matches the break on the socket.
1
Unlocked retaining clip
2
DDR2 DIMM notch
1
A DDR2 DIMM is keyed with a notch so that it fits in only one direction. DO NOT force a DIMM into a socket to avoid damaging the DIMM.
3. | Firmly insert the DIMM into the socket | 3 |
| until the retaining clips snap back in place |
|
| and the DIMM is properly seated. |
|
Locked Retaining Clip
1.7.4Removing a DIMM
To remove a DIMM:
1.Simultaneously press the retaining clips outward to unlock the DIMM.
2
Support the DIMM lightly with
your fingers when pressing the 1 retaining clips. The DIMM might
get damaged when it flips out with extra force.
2.Remove the DIMM from the socket.
1
DDR2 DIMM notch
Chapter 1: Product introduction |