5.Floppy disk drive connector (34-1 pin FLOPPY)

This connector is for the provided floppy disk drive (FDD) signal cable. Insert one end of the cable to this connector, then connect the other end to the signal connector at the back of the floppy disk drive.

Pin 5 on the connector is removed to prevent incorrect cable connection when using an FDD cable with a covered Pin 5.

The Floppy Disk Drive cable is purchased separately.

FLOPPY

PIN1

P5QL-CM

NOTE:Orient the red markings

on the floppy ribbon cable to PIN 1.

P5QL-CM Floppy disk drive connector

6.Chassis intrusion connector (4-1 pin CHASSIS)

This connector is for a chassis-mounted intrusion detection sensor or switch. Connect one end of the chassis intrusion sensor or switch cable to this connector. The chassis intrusion sensor or switch sends a high-level signal to this connector when a chassis component is removed or replaced. The signal is then generated as a chassis intrusion event.

By default, the pin labeled “Chassis Signal” and “Ground” are shorted with a jumper cap. Remove the jumper caps only when you intend to use the chassis intrusion detection feature.

P5QL-CM

+5VSB_MB

Chassis Signal GND

 

CHASSIS

P5QL-CM Chassis intrusion connector

ASUS P5QL-CM

1-25