P5WDG2-WS

PRI_IDE

P5WDG2-WS IDE connector

NOTE: Orient the red markings (usually zigzag) on the IDE ribbon cable to PIN 1.

3 . ICH7R Serial ATA connectors (7-pin SATA1 [red],SATA2 [red], SATA3 [black], SATA4 [black])

These connectors are for Serial ATA signal cables for Serial ATA hard disk drives.

If you installed Serial ATA hard disk drives, you can create a RAID 0, RAID 1, RAID 10, and RAID 5 configuration with the Intel¨ Matrix Storage Technology through the onboard Intel¨ ICH7R RAID controller.

¥ These connectors are set to Standard IDE mode by default. In Standard IDE mode, you can connect Serial ATA boot/data hard disk drives to these connectors. If you intend to create a Serial ATA RAID set using these connectors, set the Configure SATA As item in the BIOS to [RAID]. See section Ò4.3.6 IDE ConfigurationÓ for details.

¥For RAID 5, use at least three hard disk drives. For RAID 10, use at least four hard disk drives. Use two to four Serial ATA hard disk drives for each RAID 0 or RAID 1 set.

P5WDG2-WS

 

GND SATA TXP3 SATA TXN3 GND SATA RXN3 SATA RXP3 GND

 

GND SATA TXP2 SATA TXN2 GND SATA RXN2 SATA RXP2 GND

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

SATA4

GND SATA_TXP1 SATA_TXN1 GND SATA_RXN1 SATA_RXP1 GND

SATA3

GND SATA_TXP0 SATA_TXN0 GND SATA_RXN0 SATA_RXP0 GND

P5WDG2-WS SATA connectors

SATA2SATA1

ASUS P5WDG2-WS

2 - 35