2.ATX power connectors (24-pin EATXPWR, 4-pin ATX12V)

These connectors are for ATX power supply plugs. The power supply plugs are designed to fit these connectors in only one orientation. Find the proper orientation and push down firmly until the connectors completely fit.

EATX12V EATXPWR

DC DC

+3

Volts

+12V +12V

+12

Volts

 

+12

Volts

 

+5V Standby

 

Power OK

 

PIN 1

GND

GND GND

 

+5

Volts

 

GND

8 054@+;5

+5 Volts

 

 

GND

 

+3

Volts

 

+3

Volts

PIN 1

GND

+5 Volts

+5 Volts

+5 Volts

-5 Volts

GND

GND

GND

PSON#

GND

-12 Volts

+3 Volts

8 054@+;5)<@XW_MZKWVVMK\WZ[

• For a fully configured system, we recommend that you use a power supply unit (PSU) that complies with ATX 12 V Specification 2.0 (or later version) and provides a minimum power of 350 W.

•DO NOT forget to connect the 4-pin ATX +12V power plug. Otherwise, the system will not boot up.

•We recommend that you use a PSU with higher power output when configuring a system with more power-consuming devices. The system may become unstable or may not boot up if the power is inadequate.

•If you are uncertain about the minimum power supply requirement for your system, refer to the Recommended Power Supply Wattage Calculator at http://support.asus. com/PowerSupplyCalculator/PSCalculator.aspx?SLanguage=en-us for details.

3.Serial port connector (10-1 pin COM1)

This connector is for a serial (COM) port. Connect the serial port module cable to this connector, then install the module to a slot opening at the back of the system chassis.

COM1

PIN 1

8 054@+;5

8 054@+;5;MZQITXWZ\+75KWVVMK\WZ

The COM module is purchased separately.

1-18

ASUS P8H61-M LX2 Series