These connectors are for ATX power supply plugs. The power supply plugs are designed to fit these connectors in only one orientation. Find the proper orientation and push down firmly until the connectors completely fit.
ATX12V EATXPWR
+12V DC +12V DC
PIN 1
GND
GND
+3 Volts |
|
|
|
|
|
| GND | ||
|
|
|
| ||||||
|
|
|
|
|
| ||||
+12 | Volts |
|
|
|
|
|
| +5 Volts | |
+12 | Volts |
|
|
|
|
|
| +5 Volts | |
+5V Standby |
|
|
|
|
|
| +5 Volts | ||
Power OK |
|
|
|
|
|
| |||
| GND |
|
|
|
|
|
| GND | |
+5 Volts |
|
|
|
|
|
| GND | ||
| GND |
|
|
|
|
|
| GND | |
+5 Volts |
|
|
|
|
|
| PSON# | ||
| GND |
|
|
|
|
|
| GND | |
+3 | Volts |
|
|
|
|
|
| ||
+3 | Volts |
|
|
|
|
|
| +3 Volts | |
| PIN 1 |
|
|
|
|
|
| ||
• For a fully configured system, we recommend that you use a power supply unit (PSU) that complies with ATX 12 V Specification 2.0 (or later version) and provides a minimum power of 350 W.
•DO NOT forget to connect the
•We recommend that you use a PSU with higher power output when configuring a system with more
•If you are uncertain about the minimum power supply requirement for your system, refer to the Recommended Power Supply Wattage Calculator at http://support.asus.
This connector is for a
By default, the pin labeled “Chassis Signal” and “Ground” are shorted with a jumper cap. Remove the jumper caps only when you intend to use the chassis intrusion detection feature.
+5VSB_MB | Chassis Signal GND |
| CHASSIS |
ASUS |