Realtek PXE OPROM [Disabled]
This item appears only when you set the previous item to [Enabled] and allows you to enable or disable the PXE OptionRom of the Realtek LAN controller. Configuration options: [Enabled] [Disabled]
Asmedia USB 3.0 Controller [Enabled] (P8H61/USB3 R2.0 only)
[Enabled] | Enables the onboard USB 3.0 controller. |
[Disabled] | Disables the controller. |
Asmedia USB 3.0 Battery Charging Support [Disabled] (P8H61/USB3 R2.0 only)
This item appears only when the Asmedia USB 3.0 Controller item is set to [Enabled].
[Enabled] | Enables the Asmedia USB 3.0 battery charging function. |
[Disabled] | Disables this function |
Serial Port Configuration
The
Serial Port [Enabled]
Allows you to enable or disable the serial port (COM).
Configuration options: [Enabled] [Disabled]
Change Settings [IO=3F8h; IRQ=4]
Allows you to select the Serial Port base address. Configuration options: [IO=3F8h; IRQ=4] [IO=2F8h; IRQ=3] [IO=3E8h; IRQ=4] [IO=2E8h; IRQ=3]
Parallel Port Configuration
The
Parallel Port [Enabled]
Allows you to enable or disable the parallel port (LPT).
Configuration options: [Enabled] [Disabled]
Change Settings [Auto]
Allows you to select an optimal setting for Super I/O devices. Configuration options: [Auto] [IO=378h; IRQ=5;] [IO=378h; IRQ=5,6,7,9,10,11,12;] [IO=278h; IRQ=5,6,7,9,10,11,12;] [IO=3BCh; IRQ=5,6,7,9,10,11,12;]
Device Mode [STD Printer Mode]
Allows you to change the printer port mode. Configuration options: [STD Printer Mode] [SPP Mode]
2.5.7APM
Restore AC Power Loss [Power Off]
[Power On] | The system goes into on state after an AC power loss. |
[Power Off] | The system goes into off state after an AC power loss. |
[Last State] | The system goes into either off or on state, whatever the system state was |
| before the AC power loss. |
Chapter 2: BIOS information |