1.From the utility main menu, select 5. Exit, and then press <Enter>. The following warning message appears:
[ CONFIRM EXIT ]
Are you sure you want to exit? (Y/N):
2.Press <Y> to exit or press <N> to return to the utility main menu.
5.1.5Marvell RAID utility
The onboard Marvell SATA 6.0 Gb/s controller allows you to create a RAID 0 or RAID 1 array using two SATA hard disk drives. Refer to the section 1.2 Motherboard overview in your motherboard user manual for the exact location of the Marvell SATA 6.0 Gb/s connector.
To enter the Marvell utility, press <Ctrl> + <M> during POST.
All exisiting data on the hard disk drives will be erased when creating or deleting a RAID array. Ensure that you have back up all your data in your hard disk drives before making any change to the drive status.
Marvell BIOS Setup (c) 2009 Marvell Technology Group Ltd.
Topology | Information |
|
|
HBA 0: Marvell 0 | Vendor ID | : | 1B4B |
├ Virtual Disks | Device ID | : | 9130 |
└ Free Physical Disks | Revision ID | : | B1 |
├ PD 0: ST3160812AS | BIOS Version | : | 1.0.0.1028 |
└ PD 8: ST3160812AS | Firmware Version: | 2.2.0.1105 | |
| PCIe Speed Rate : | 5.0Gbps | |
| Configure SATA as: | AHCI Mode | |
▶
Help
Marvell RAID on chip controller.
ENTER: Operation F10: Exit/Save ESC: Return
Chapter 5
ASUS |