2.9Installing an optical drive

The S-presso system comes with one optical drive bay. Refer to this section to install an optical drive.

Set your optical drive as Slave device before connecting the IDE cable and power plug. Refer to the optical drive documentation on how to set the drive as a Slave device.

To install an optical drive:

1.Drive a screw on each side of the optical drive as shown.

2.Remove the front panel. Refer to section “2.3 Removing the front panel” for instructions.

3. Slide the optical drive into the optical drive bay.

4.Push the optical drive until the hinge lock snaps the screws into place.

2 - 14

Chapter 2: Basic installation