Asus TX97-LE ASUS TX97-LEUser’s Manual, 10.AT Power Supply Connector (POWER, 12-pinblock), 9.ATX Power Supply Connector (ATXPWR, 20-pinblock)

III.INSTALLATION

9.ATX Power Supply Connector (ATXPWR, 20-pin block)

This connector connects to a ATX power supply. The plug from the power supply will only insert in one orientation because of the different hole sizes. Find the proper orientation and push down firmly making sure that the pins are aligned.

IMPORTANT: Make sure that your ATX power supply can supply at least 10mAmp on the 5-volt standby lead (5VSB). You may experience difficulty in powering on your system if your power supply cannot support the load. For Wake on LAN support, your ATX power supply must supply at least 720mAmp.

+3.3	Volts	+3.3 Volts
-12.0 Volts		+3.3 Volts
Ground		Ground
Power Supply On		+5.0 Volts
Ground		Ground
Ground		+5.0 Volts
Ground		Ground
-5.0	Volts	Power Good
+5.0	Volts	+5V Standby
+5.0	Volts	+12.0 Volts

ATX Power Connector

10.AT Power Supply Connector (POWER, 12-pin block)

This connector connects to a standard 5 Volt power supply. To connect the leads from the power supply, ensure first that the power supply is not plugged. Most power supplies provide two plugs (P8 and P9), each containing six wires, two of which are black. Orient the connectors so that the black wires are together.

+5V		RED
		RED
			P9
		RED
	-5V	WHT
		BLK
GND		BLK
		BLK
		BLK
	-12V	BLU	P8
+12V		YLW
	+5V	RED
PG		ORG
Power Connector		Power Plugs from
on Motherboard		Power Supply

AT Power Connector

Using a slight angle, align the plastic guide pins on the lead to their receptacles on the connector. Once aligned, press the lead onto the connector until the lead locks into place.

INSTALLATION	(Connectors)
III.

ASUS TX97-LE User’s Manual 29