AT&T 100 user manual Wall Installation

WALL INSTALLATION

1.Set Dial Mode switch This product comes set in the tone (TT) mode. Make sure you choose the correct dialing method (TT/DP); touch tone dialing will not work if you have dial pulse service.

2.Connect the line cord and install telephone on wall jack

Plug the three-inch line cord into the back of the telephone and into a modular wall jack. Then align the mounting slots on the back of the telephone with the studs on the wall jack. Push the telephone firmly against the wall jack, and pull down until it is held securely by the mounting studs.

3.Connect handset to telephone base

Plug one end of the coiled handset cord into the handset. Plug the other end into the jack at the base of the phone. Then hang up.

4.Check for dial tone

Lift the handset and listen for a dial tone. If you can't hear a dial tone, refer to “In Case of Difficulty” and try to correct the problem.

TO DISCONNECT the line and handset cords, squeeze the clip on the modular plug and pull it out of the jack.

Dial Mode Switch

3