I N C A S E O F D I F F I C U L T Y
If the system does not respond to remote commands:
•Make sure you are calling from a touch tone telephone. If you hear clicks when you dial, the phone is not a touch tone phone.
•There might be noise or interference on the phone line. Press dial buttons firmly.
•Make sure you are entering the correct Remote Access Code.
If you forget your Remote Access Code:
1Unplug the answering system.
2Hold down Pand plug the system back in. You’ll hear three short beeps, followed by a long beep.
3Release P. The Remote Access Code has been reset to 1234 (the Priority Calling Code is 1235).
4To change the Remote Access Code, see “Changing Your Remote Access Code” in the REMOTE OPERATION section of this manual.
If you’re having a problem not described above:
1Unplug the power cord.
2Remove the microcassette, turn it over, and reinstall it.
3Wait about one minute, then plug the power cord into the electrical outlet. The system will rewind the tape.
4When the tape stops (after about one minute), record an announcement.
11
