INSTALLATION
Table/Desk Installation
¥NOTE: Install this telephone away from electronic equipment, such as personal computers,television sets or microwave ovens. Avoid excessive heat,cold, dust or moisture.
1Connect the corded handset to the base.
2Connect the telephone line cord. (figure a)
3Connect the power cord to the base and an electrical outlet not controlled by a wall switch. (figure a) The answer ON/OFF light goes on, and CL flashes in the message window.
Use only the power cord supplied with this product. If you need a replacement, call
4Check for dial tone .
•Lift the handset, you should hear a dial tone.
¥NOTE: For Wall Mount Installation see page 5 in the User Manual.
Handset Charger Installation
QUICK START GUIDE
2.4GHz Corded Cordless Telephone with Caller ID/Call Waiting 1485/1185
Standard | Modular |
electrical | telephone |
outlet | jack |
Power Cord
Line Cord
figure a
a)Remove battery compartment cover by pressing on the indentation and sliding downward.
1 | Connect the power cord. Be sure to plug the cord |
into an electrical outlet not controlled by a wall | |
switch. | |
2 | Install the handset batter y. Use NiCd Replacement |
| Battery 3301,SKU# 91076. (figure b) |
3 | Charge the handset battery. |
| • Place the handset in the remote charging |
| stand.The CHARGING light goes on. |
c)Place battery pack in compartment with the wires in the lower left corner, along the bottom of the battery pack.
b)Align two holes in plug with socket pins, and snap the plug into place.
• | Charge the battery at least 12 hours. | |
4 Check for dial tone. | ||
• | After the batteries are charged,lift the handset | |
and press | ; you should hear a dial tone. | |
d) Replace cover by sliding it up into place.
