AT&T 1722 Announcement Announcement, Monitor, Store Number, Accept, Blocked Calls, Audible

FEATURE SETUP

Feature Summary continued

FEATURE:	SYSTEM	OPTIONS:
	ANNOUNCES:
ANNOUNCEMENT “ANNOUNCEMENT		Choose ON to hear the announcement
MONITOR	MONITOR IS...”	when your system answers a call. Choose
		OFF to have it silent on your end. (Your
		caller will still hear the announcement.)
		NOTE: Volume must be set to a
		level you can hear to use
		Announcement Monitor.
NUMBER	“NUMBER	When this feature is on, the system will
ANNOUNCE	ANNOUNCE IS...”	announce the caller’s telephone number
(Please see		between the second and third rings.
NOTE below.)
		NOTE: When the Number Announce
		feature is on and Ring Select is set for
		two rings, the unit will answer after
		three rings to allow enough time for
		the system to announce the caller’s
		telephone number.
STORE NUMBER	“STORE NUMBER IS...”	When this feature is on, the system
(Please see		announces the caller’s telephone
NOTE below.)		number when it plays back a message.
ACCEPT	“ACCEPT BLOCKED	Choose ON to have the system accept
BLOCKED CALLS	CALLS IS...”	all calls. Choose OFF to have the system
(Please see		respond to “blocked” calls with the
NOTE below.)		pre-recorded announcement, “WE’RE SORRY,
		BLOCKED CALLS TO THIS NUMBER CANNOT BE
		ACCEPTED,” and hang up without recording
		a message.
AUDIBLE	“MESSAGE ALERT IS...”	When this feature is on, the system beeps
MESSAGE ALERT		every 15 seconds when you have new
		messages.

NOTE: For this feature to work, you must subscribe to Caller Identification service from your telephone service provider. There is a fee for this service, and it may not be available in all areas.

3