AT&T 9105 Setting up the Cordless, Telephone, Connect the power cord, Set the dial mode switch

INSTALLATION

Standard power outlet

1	Setting up the Cordless
	Telephone 9105.
	• Choose an area near an electri-
	cal outlet and a telephone jack.
	• The outlet should not be
	controlled by a wall switch.
2	Connect the telephone line cor d.
	• Insert one end of the telephone
	line cord into the jack at the
	rear of the base unit. Plug the
	other end into a telephone jack.
	Make sure the plugs snap
	securely into place.
3	Connect the power cord.
	• Plug the AC power adapter into
	a standard electrical outlet and
	the DC connector into the
	power jack located at the rear of
	the base unit.
	• Wrap the power cord around the

Power cord Telephone line cord Telephone jack

Strain relief hook

Power jack

Telephone jack

Slots

Base unit

Slots

Tabs

Reversible base

Clips

Thicker end

strain relief hook on the bottom

of the base unit (see illustration).

The strain relief hook helps

protect the power cord from

accidentally being removed.

CAUTION: Use only the AC power adapter supplied with this telephone . This is a Class 2 AC adapter, specifi- cally designed for use with the 9105.

NOTE: Connect power to the base unit before placing the handset in the cradle.

4Set the dial mode switch.

If you have touch tone service on your phone line, set the switch located on the bottom of the base to TONE. If you have rotary service, set the switch to PULSE.

5Install the handset battery.

•Remove the handset battery cover by pressing the indentation on the handset battery cover and sliding the cover downward.

•Place the handset battery pack in the compartment. Make sure the metal contacts on the under- side of the battery are aligned with the charging contacts in the handset battery compartment.

•Replace the handset battery cover by sliding it on its track up and over the handset battery compartment until it snaps firmly in place.

2