18
ANSWERING SYSTEM OPERATION
AT THE BASE
Answering System Feature SetupYou can set up one feature at a time,or you can set up a feature and then
move on to set up another feature.
1Make sure the answering system is on.
2Press and release Uuntil you hear the system announce the
feature you want to se t. Refer to the “Feature Summary”below for a
description of the features and your choices.
3Press Sto hear the feature’s settings.
4Press tto confirm your selection.
Feature SummaryDefault settings indicated by *.
System announces: Description/directions:
“Change remote access code” Set the remote access code you will use
19 *to access features and functions of the
answering system from a touch tone phone.
“Change clock” Set the clock: After you set the day,repeat
Steps 3 and 4in “Answering System
Feature Setup”to set hours and minutes.
“Change message alert” When Message Alert is turned on,the base
Off *beeps once every 10 seconds when new
On messages have been received.
“Change announce only” When you turn Announce Only on,callers
Off *hear your announcement,but cannot
On leave a message.
“Change base ringer” Turn the base ringer on or off.
On *
Off
“Change number of rings” Choose how many times the phone will
2 ring before the system answers a call.
4*With Toll Saver active, the system answers
6 after two rings when you have new
Toll Saver messages and after four rings when you
have no new messages.
NOTE: Exit Feature Setup at any time by pressing an MBOX/STOP button.
9357_book/wc_1ATT 7/6/01 4:10 PM Page 18