AT&T AT3211-2 quick start Telephone base installation, Install the telephone base as shown below

Telephone base installation

Install the telephone base as shown below.

5. Plug the other end of the telephone line cord into a telephone wall jack.

If you have DSL high speed Internet service, a DSL filter (not included)

is required.

. Route the telephone line cord through the channel.

6. Plug the large end of the power adapter into a power outlet not controlled by a wall switch.

1. Plug the small end of the power adapter into the power jack on the bottom of the telephone base.

. Route the power adapter cord through the channel.

. Plug one end of the telephone line cord into the telephone jack on the bottom of the telephone base.

IMPORTANT INFORMATION

1.Use only the power adapter(s) supplied with this product. To order a replacement

power adapter, please call the appropriate number listed below based on your location: If you live in CT, please call 1 (800) 508-9995.If you live in AL, FL, GA, KY, LA, MS, NC, SC or TN, please call 1 (800) 733-2355.For all other states, please call 1 (800) 667-2118.

. The power adapters are intended to be correctly oriented in a vertical or floor mount position. The prongs are not designed to hold the plug in place if it is plugged into a ceiling, under-the-table or cabinet outlet.