FIGURE 4
FIGURE 5
FIGURE 6
■Adjusting the Voice Tube
With one hand, hold the capsule securely against your head, With your other hand, pull out or push in the voice tube and rotate the tip so it is approximately 1/2" away from your face at the corner of your mouth. (Refer to FIGURE 4)
Maintenance Hint for Optimum Performance
Replace your voice tube every six months.
■Attaching Mirage® to Glasses
Mirage is designed to fit comfortably with glasses. If you desire a more secure fit, use the Eyeglass Clip. Attach the clip to the side that you wear your headset.
1A For plastic frames, slip the clip onto the temple of your glasses with the grips for the headset facing away from your head. (Refer to FIGURE 5A)
BFor metal or wire frames, pull back the tab on top of the clip. Then, slip the clip onto the temple of your glasses with the grips for the headset facing away from your head. The clip should be secure when the tab is released. (Refer to FIGURE 5B)
2Attach the headset by slipping the voice tube balljoint into the clip. (Refer to FIGURE 5B)
■Quick Disconnect
Your headset model is equipped with a Quick Disconnect module. This feature allows you to place a call on hold with- out removing your headset, thus freeing you to perform a task away from the phone. Your conversation is quickly resumed by reconnecting the Quick Disconnect.
1Before attempting to use your headset, be sure that the two Quick Disconnect halves are connected.
2To put your call on hold, grasp the Quick Disconnect as shown and pull straight apart. (Refer to FIGURE 6)
3To resume your conversation, reconnect the two halves of the Quick Disconnect.
3
